LED Remote Sync (Generation 1 – No arrow on back)

Gen 1 – No arrow on back of remote Gen 2 – with arrow on back of remote

Gen 1 LED Sync Video Gen 2 LED Sync Video

 

 

Code Matching (Gen 1): Pairing your Gen 1 LED Remote

Please follow the instructions below:

  • Confirm it is correctly connected between power supply, LED controller & LED load.
  • Switch the power off, then switch it on again, & press key 5 once (within 3 seconds) the moment you see the light is on.
  • The LED will blink twice slowly when it is completed.

Code Clearing (Gen 1): Unpairing your Gen 1 LED Remote

The code can be cleared as needed. The kit (remote & controller) will stay in the original state after code clearing and can work again when code re-matching is done.

Code Clearing Cont. (Gen 1):

Confirm it is correctly connected between power supply, LED controller & LED load.

  • Switch the power off, then switch it on again, & long press key 5 (within 3 seconds) the moment you see the light is on.

The LED blinks 9 times swiftly when completed.

Code Matching (Gen 2): Pairing your Gen 2 LED Remote

Please follow the instructions below:

  • Confirm it is correctly connected between power supply, LED controller & LED load.
  • Switch the power off (either at the source of the fireplace or with the SIT Remote using the light bulb indicator), then switch it back on, & press keys 1 & 10 simultaneously at once (within 3 seconds) the moment you see the light is on.
  • The LED will blink twice slowly when it is completed. Press color wheel to verify change of color. If color does not change, repeat above steps.
  • There is no code clearing on Gen 2 LED Remotes